Linksys wrt54g hook up, search this blog
Why Do I Want To Do This?
See the included readme for additional information. Reboot the router using the command "reboot" after using this method. Insert the two-pronged AC adapter for the Linksys router into a wall outlet.
Unfortunately, I was limited to what I had on hand at the time. I recommend starting off with the ground wires, pin3 and pin 6.
You can click on the image to get a larger view if you need it. Click the "Save Settings" button and write down the password for future reference.
Horrible Customer Support Average rating: What Do I Need?
Disable The next step is to turn off the radio completely which not only kills the Wi-Fi but actually powers the physical radio chip off. Before we get started, two things: Make sure the firmware you are going to use is the correct type for your router.
Pin 6 second from the left on the lower side of the resistor network goes to the CLK pin 5 of the SD card, while pin 7 of the resistor network is wired to DO pin 7 of the SD card.
Preparing Your Router for Life as a Switch Before we jump right in to shutting down the Wi-Fi functionality and repurposing your device as a network switch, there are a few important prep steps to attend to.
It is important that both pins be brought together. When do you need a network switch?
The default maximum connections in Tomato is The first one is used as a router and wireless access point and the second one is just an extender of that wireless and wired network. Besides the visible GUI change, a lot of the code inside has also undergone extensive changes to add new features, fix problems, optimize and reduce the size.
Since they have the same SSID, I can drag my laptop from one end of the house nearer the main router to the other end of the house nearer the second router access point and always have a very strong wireless signal.
Click "Save Changes" to encrypt the network. The CFE and config areas are constant in size, but the firmware size may change when you upgrade.